We have merged the sensors list for our European office into SCWin, eliminating the need for two versions. If terminal input modules (TIMs) are being used, the wiring diagram in SCWin now supports them. Data storage to PCMCIA or CompactFlash cards has been added for the CR1000 and CR5000 dataloggers.
Added support for alternative groups of sensor files, specifically to support sensor files developed for sensors specific to European users. The SCWin.EXE was modified to read new settings in the sensor files and display a menu item under the Settings menu to offer options for viewing Campbell Scientific Inc. or Campbell Scientific Ltd. sensor groups.
Added support for interfaces requiring special wiring between the data logger and sensors: LLAC4 (4-channel device for reading low-level ac signals on digital control ports), SW12V (standalone switched 12V relay cable for HMP45C sensors), Terminal Input Modules for the AGS Level Sensor and CNR1 Net Radiometer, A547 Interface for the CS547A Conductivity and Temperature Probe, QD1 Interface for quadrature shaft encoders, SDM-AO4 4-Channel Analog Output Module, and SDM-CVO4 4-Channel Current/Voltage Output Module.
Added support for outputting data to the CFM100 CompactFlash Module from the CR1000.
Added new sensor files:
107 Temperature Probe (4-wire version) for multiplexers
108 Temperature Probe (3-wire) for multiplexers
108 Temperature Probe (4-wire) for multiplexers
AGS Level Sensor (Metritape)
CNR1 Net Radiometer
CS100 Barometric Pressure Sensor
CS205-LC Fuel Temperature Sensor for the MetData1 and ET106
CS215 Temperature & Relative Humidity Sensor
CS505-LC Fuel Moisture Sensor for the MetData1 and ET106
CS512 Dissolved Oxygen Probe
HMP45C (6-wire) Temperature & Relative Humidity Sensor on the SW12V
NRG #200P Wind Direction Sensor
NRG #40 Wind Speed Sensor
Device for Analog Input from SDM-AO4
Device for Current/Voltage Input from SDM-CVO4
WindSonic-LC 2-D Sonic Wind Sensor for the MetData1