All FAQs (1865 total: showing 1701-1720)
- Does CRBasic have to be used to program a datalogger? Does a menu-driven program generator exist for the datalogger?
- What is the overall length of the CR1000 (including screw tabs) when the CFM100 or NL115 module is added to the wiring panel/interface of the CR1000?
- How can I use a datalogger to measure solar radiation?
- Can just the plastic, three-prong cup part of the anemometer be replaced on a weather station?
- What is the conversion for evapotranspiration using wheat instead of turf grass? Also, is there anything for bare soil?
- What is the 229-L heating element made of? In an acidic environment, such as copper mine tailings, would the sensor be expected to fail because of corrosion within five years?
- I have an old CR-10 data logger that has not been used in years. The problem I am having is as soon as the power is shut off, all the data and programs are lost. Is there anyway to prevent this?
- What is the optimum calibration frequency for a WindSonic?
- Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
- Where is the interface cable for the WindSonic?
- Do you have 1-d anemometer having 4 Hz or higher frequency to measure the vertical wind velocity?
- Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
- Can the WindSonic produce an output of 4 Hz or higher frequency?
- The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
- Is it possible to connect a sonic anemometer and an electronic compass to a smart datalogger to give wind speed and direction on a non-fixed platform?
- What is the reliability rating of the WindSonic?
- Can the CR5000 store data with a rate of 1000 Hz?
- If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
- Can the CR1000 or CR3000 communicate over TCP/IP?
- Can the CR1000 provide alarms?
Anterior
Siguiente