What needs to be done to set up EasyFlux® DL?

To set up EasyFlux® DL, follow these steps:

  1. Open EasyFlux® DL in a text editor, such as the CRBasic Editor.
  2. Set the instrument constants (for example, which sensors are being measured).
  3. Load EasyFlux® DL just like any other data logger program using LoggerNet software.
  4. After all the sensors are installed and wired, use the CR3000 keypad or CR1000KD (for CR6) to set or fine-tune the station variables (for example, measurement height, canopy height). The instruction manual provides step-by-step instructions for this process.

Esto fue útil

Inicio FAQs