All FAQs (1868 total: showing 581-600)
- What is necessary for making strain gage measurements with Campbell Scientific data loggers?
- What is used to wire an AVW200-series module to the control ports on the CR3000, CR1000, or CR800?
- Can a CR3000, CR1000, or CR800 communicate with an AVW200-series module via an RS-232 port?
- How fast can the AVW200, AVW206, AVW211, or AVW216 make a measurement?
- How many AM16/32B multiplexers can be attached to one AVW200-series module?
- What might cause an AVW200-series module to not communicate with a datalogger?
- In a wireless network, can the radio of an AVW206, AVW211, or AVW216 translate data from other AVW200-series modules?
- How many AVW200-series modules can communicate with a CR1000?
- Is there a way to request and obtain the voltage and radio signal strength from a remotely located AVW206 using CRBasic?
- How strong is the signal of the built-in radio on the AVW206, AVW211, and AVW216?
- Is an AVW200-series module required on vibrating wire transducers to limit noise?
- Is there a reset button on the AVW200, AVW206, AVW211, or AVW216?
- What are the differences between the AVW200, AVW206, AVW211, and the AVW216?
- Is a 17394 connected to an SC32B basically the same as an SC-USB?
- How do the 17934, the SC32B, the SC929, and the SC-USB compare?
- When a CWS655 is put in water, why does the volumetric water content read NAN?
- How can it be determined if the NAN values are caused by soil conditions or a faulty CWS655?
- Why is the electrical conductivity (EC) reading NAN on a CWS655?
- On the CWS655, is it possible to disable the logic that causes NAN values?
- Why is the permittivity reading NAN for the CWS655?
Anterior
Siguiente