All FAQs (1887 total: showing 1741-1760)
- Can the CR1000 or CR3000 communicate over TCP/IP?
- Can the CR1000 provide alarms?
- Can the CR1000 measure 4 to 20 mA signals?
- Can I use the digital camera with my RF network and transmit the images back to the office using Loggernet?
- I am trying to set up a CC640 with a CR10x (not the 2M variety) to send images via a freewave radio. I'm wondering if I need loggernet 3 (I have 2) or if I just need the lvcmd.exe file to view these pics through the logger?
- What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
- The measurement instructions will likely remain the same but in addition to the multiplier and offset, the type of pulse may change for the wind speed and the excitation voltage may change for the wind direction. The manual easily explains how the logger needs to be programmed.
- If I replace an existing wind set with the wind monitor, will I have to change more than the multiplier and offset in the datalogger program?
- What is the power consumption (mA) of the 05103-L, 05305-L, 05108-L, and 05108-45-L anemometers?
- What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
- I'm trying to interface with a 21X (s/n 3329) with an IBM thinkpad, using an SC32B connected to a radioshack RS-232 to USB adapeor. This connection has worked with two CR10X dataloggers and a CR10 datalogger. However, it does not work with the 21X. Do you have any suggestions?
- Can I install the 21X Micrologger to capture soil water?
- Can the CR5000 store data with a rate of 1000 Hz?
- When I dial up to the unit I can see the barometric pressure data in real time. When I attempt to collect data from the unit via dial up or even via storage module, the barometric data are all 0's.
- How do you transfer data from the 21X to Storage Module?
- Which battery packs are recommended for use with the 21X datalogger?
- I am looking for information on the 21X datalogger. Removal of the expansion memory module to be specific . I was trained on the CR10X in Edm, but have no info on the 21X.
- Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?
- Do heater resistance values of 37 to 48 ohm indicate a problem with the 229-L, or are those values within the normal range?
- Is there a limit to how much memory the CR5000 can access/use through the PCMCIA interface?
Anterior
Siguiente