FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1887 total: showing 1421-1440)

Why is it important for the SC32B to be optically isolated?
What is needed to set up a communication network for an eddy-covariance system in a remote location?
Can an ENC16/18 be used with an enclosure heater to increase the inside temperature and reduce the risk of condensation?
Can converters to 18 Vac and 12 Vdc be located within an ENC16/18 without affecting the datalogger or data?
Can 120 Vac be brought into the ENC16/18?
How many mounting accessories should be ordered for each major device inside an enclosure?
Is a fiberglass enclosure suitable for an installation in a very cold location monitoring corrosion?
If the copper ground terminals attached to the bottom of an enclosure are oxidized and corroded, how can they be replaced?
What are the distances, center-to-center, of the mounting holes in the back of the ENC14/16?
If the PVC fittings at the bottom of the enclosure have too small an inner diameter to accommodate all the cables passing through, is there a way to remove the PVC fittings?
What is the preferred method for punching a clean hole through the bottom of an enclosure?
Can just the backplate of an enclosure be purchased?
Does the enclosure have a mounting bracket inside to mount the datalogger?
How often should the fuel temperature and moisture dowels be replaced?
Where is there a picture with part numbers for the fuel moisture sensor, fuel temperature stick, temperature probe, and mounting stake?
Is it possible to make a portable system that can use a TDR100, a data logger, and a TDR probe to sample on command via a switch?
How can both a TDR100 and an SDM-IO16 be connected to a single CR1000 or CR800?
Is it possible to connect more than one TDR100 to a datalogger using different SDM addresses?
How can data from a TDR100 be downloaded to a laptop when only a USB port is available?
What help is available for using the TDR100 for a slope stability/rock mass deformation measurement application?

Anterior Siguiente