Toggle navigation
Productos
Soluciones
Soporte
Acerca de
Inicio
Productos
Soluciones
Soporte
Acerca de
Lista cotización
Contacto
Sitios web regionales
Sitios web regionales
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Directorio paises
Log In
FAQs
Preguntas frecuentes acerca de nuestros productos y soluciones
Realizar consulta
Realizar consulta
Buscar
All FAQs
(1868 total: showing 1161-1180)
Can the three communications interfaces of the MD485 be used simultaneously?
How is PakBus Networking mode different from Transparent Communications mode?
What protocols is the MD485 compatible with?
Is the MD485 compatible with other half-duplex RS-485 devices?
How many MD485 devices can exist on a single network?
How long can the cables be between MD485 and RS-485 devices?
Is there any way to use an SDM cable longer than 20 feet?
Can the SDM-CD8S be used to switch ac loads?
Can the SDM-CD16S be used to switch the negative side of dc loads?
Is there a manual override on the SDM-CD8S or SDM-CD16S?
Can an SDM address be changed quickly and easily?
Can multiple SDM-CD8S or SDM-CD16S devices be connected to a single data logger?
If an SDM-CD8S or SDM-CD16S is used to switch an inductive load (solenoid), is a diode needed to protect against voltage kickback, or is one already built into the device?
What is the warm-up time for the CS100 or CS106?
Why might measurements with a CS100 or CS106 be bouncing (noisy)?
Does the CS100 or CS106 need to be vented to the outside of an enclosure or building?
To replace a CS105 with a CS106 in an existing system, does anything extra need to be ordered?
Is the CS106 a direct replacement for the CS105?
How often should the CS100 or CS106 be factory calibrated?
What are the multiplier and offset values used with a CS100 or CS106?
Anterior
Siguiente