Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Thies 2d ultrasound anemometer connected to CR1000

Muhammad Nov 20, 2019 01:42 PM

Hi,

can anyone help ne to program the CR1000 in order to get the measured values of a Thies 2d Ultrasound anemometer (https://www.thiesclima.com/pdf/en/Products/Wind-Ultrasonic-Anemometer/?art=145). I am using Loggernet to comunicate with the datalogger and schort cut to generate and sent programs.

Thank you all.

JDavis Nov 20, 2019 03:28 PM

If using ShortCut to create your program, you will need to use the voltage output from the sensor. Adjust the scaling in the sensor, so the maximum wind speed and direction outputs will not exceed 5VDC. You will just need to do two single ended voltage measurements.

Muhammad Nov 21, 2019 09:07 AM

Thanks for your reply. I have no Idea how to adjust it within the code. could you please help?

Log in or register to post/reply in the forum.