FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

Can the burst mode be used with a CR5000? If so, what is the maximum sampling rate?

Yes, burst mode can be used. The maximum sampling rate depends on the number of sensors and the integration.

Esto fue útil

Inicio FAQs

FAQs similares

How do long cable lengths affect measurements?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the datalogger to have a fixed IP address?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
Can the CR6 have simultaneous communications (that is, Ethernet and USB) at the same time between two different computers?
What's the difference between the CR10X and CR10?
¿Pueden conectarse simultáneamente al datalogger más de un dispositivo SDM?