FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (2101 total: showing 921-940)

Can backups from older versions of LoggerNet work on newer versions?
How much memory does LoggerNet have?
Can a single copy of LoggerNet be purchased and installed on a laptop PC and a desktop office PC, or are two copies of LoggerNet needed?
Are LoggerNet upgrades free?
Where is there information about the revisions to the LoggerNet software?
Is LoggerNet included with the purchase of a data logger, or is the software sold separately?
Where is there information about the revisions to the SCWin software?
Can Short Cut be used to write a program for the CS475, CS476, or CS477?
Can a CS470 or CS471 be used to measure rainfall if the majority of the time there is no water to be measured?
How large of an enclosure is needed to house a CR1000, a 12 V battery, and a CS470 or CS471?
Can the 4 to 20 mA analog output on the CS470 or the CS471 be used with a PLC instead of a Campbell Scientific datalogger?
Using a CS470 or CS471, how can bad measurements be prevented because of river silt or mud?
What should be done to prevent a CS470 or CS471 from being damaged by the current of a river?
Do the CS470 and the CS471 require a separate gas pump or gas bottle to drive the system?
What is the maximum length of tubing that can be used with a CS470 or CS471?
Is the only difference between the CS470 and the CS471 in their accuracy?
Do the CS470 and CS471 have the same measurement range?
What is the best way to replace the sealant around the KH20 source/detector tubes?
Where is the KH20 listed as a component in the Short Cut (SCWin) program?
Is there a composite program for eddy-covariance measurements that uses the KH20?

Anterior Siguiente