FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1887 total: showing 701-720)

Can the individual measurement parameter data be retrieved separately from the ET107, in addition to the automatically calculated ETo?
What is needed to display data from the T107 or ET107 online?
Is the ET107 compatible with Calsense controllers?
Using an ET107, how can evapotranspiration be calculated based on the measured parameters?
What is the difference between the ET106 and the ET107?
Can a 10164-L Water Sampler Control Cable be used to interface Campbell Scientific dataloggers with ISCO water samplers?
What is the maximum solar panel size that can be connected to a PS100?
How long does it take to fully charge the PS100 battery?
Is there a published chart of charging voltage versus temperature for the PS100?
Can the PS100 handle a 55 W solar panel, or should an external regulator be used?
Is there a way to record the average influx of energy into the PS100 battery (that is, from a solar source)?
What are the internal and external battery connections on the PS100 used for?
Can an RV battery be used to replace the battery in the PS100?
Can the PS100 be purchased without the 7 Ah rechargeable battery?
On the PS100, what might cause the “charging voltage present” light to be off?
Should an idle PS100 be left on charge continuously, or should it be allowed to self-discharge?
Do the PS100 batteries come charged?
Is the red LED on the PS100 supposed to turn green when the battery is charged?
Will the PS100 or PS200 work as a battery backup for the CR1000?
If a group of switching power supplies is being powered by the same circuit as a PS100, will noise on the line affect the operation and accuracy of the data logger, multiplexer, and modem?

Anterior Siguiente