FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1887 total: showing 1581-1600)

How can access to the CR800 running program and data be locked?
On the CR800 or the CR850, is the EX1 the same thing as the VX1?
Is the 5 V output of the CR800 for powering peripherals a regulated output?
Which relay devices are compatible with the CR800 and the CR850?
Can the CR800 or CR850 be configured to accept an RS-232 signal input from a sensor?
Is there an add-on module available for the CR800 or CR850 that allows connectivity with a hard-wired Ethernet?
What are the backup storage options for the CR800 or CR850?
Using a CR800 or CR850 with a Wi-Fi adapter positioned near a Wi-Fi network hotspot, could a distant PC running LoggerNet collect the data logger data (or could the data logger send the data to the PC)?
What is the maximum number of user data tables that can be programmed on a CR800 or CR850?
Is it possible to communicate using PakBus over the CS I/O port on the CR800 or CR850?
What is the most basic, least expensive software that can be used to view and display data from Campbell Scientific dataloggers?
When the memory of the CR800 or CR850 is full, will it overwrite older data?
Is there any required calibration for the CR800 or CR850?
Los dataloggers Campbell Scientific, ¿disponen de memoria no-volátil?
Are there any unique cabling requirements to connect a CR800 or CR850 with a Raven XT-series modem?
If a CR800 or CR850 only has three differential channels, but four analog pressure transducers need to be connected to the datalogger, what can be done to overcome this?
Does the data from the CR800 or CR850 need to be downloaded before changing the 12 Vdc battery?
Can the CR800 or CR850 measure 4 to 20 mA signals?
Is the modem setup for a CR800 or CR850 any different than that for a CR1000, CR3000, or CR5000?
What is the required minimum voltage of the lithium battery on a CR800 or CR850?

Anterior Siguiente