FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Can more than one CDM-VW300-series device be used with one datalogger?

Yes. When more than eight channels are needed in a system, multiple CDM-VW300-series devices can be connected to the same datalogger.

• Each CDM-VW300 device provides two terminals. 
• Each CDM-VW305 device provides eight terminals.

Any combination of CDM-VW300 and CDM-VW305 devices can be used to achieve the desired number of total terminals.

The list below, ordered by datalogger and measurement rate, indicates the maximum number of supported terminals:

• CR3000, 100 Hz: 8 terminals
• CR3000, 50 Hz: 24 terminals
• CR3000, 20 Hz: 48 terminals
   
• CR1000, 100 Hz: not supported
• CR1000, 50 Hz: 8 terminals
• CR1000, 20 Hz: 32 terminals
   
• CR800-series, 100 Hz: not supported
• CR800-series, 50 Hz: 8 terminals
• CR800-series, 20 Hz: 32 terminals

FAQs similares

• En que consiste la medida de temperatura de un PRT (Pt100 / Pt1000) ?
• How can LoggerNet be upgraded to LoggerNet Admin?
• What is the default port used when LoggerNet Remote connects with a remote LoggerNet Admin or LoggerNet for Linux installation?
• Can three-wire PT100 sensors only be used with three-wire half-bridge modules, or can they also be used with four-wire half-bridge modules?
• Can one license of LoggerNet Remote be installed on multiple computers in a single network?
• ¿Cuantos sensores puede medir un datalogger?
• Can binary data be received via the serial terminal of a data logger?